beautypg.com

Extra electric outlet – Dyna-Glo Kerosene Portable Forced Air Heaters KFA400DGD User Manual

Page 8

background image

7

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

TO STOP HEATER

1. Turn operating switch to “OFF”.

This will cause heater flame to go out.

The motor will continue to run during the cooling cycle.

(Room Temp. Display will show “CC” during the cooling cycle)

This allows the fan to cool the combustion chamber. When the cooling cycle

(approx.1Min) is finished, the motor will stop.

Do not unplug heater until cooling cycle is finished.

2. Unplug power cord.

3. To temporarily stop heaters, set thermostat at a temperature lower than air around heater,

Heater will cycle back on if air temperature around heater matches thermostat setting.

TO RESTART HEATER

1. Wait until cooling cycle is finished after stopping heater.

2. Repeat steps under to start HEATER.

EXTRA ELECTRIC OUTLET

The cooling cycle cools the combustion chamber.

Figure 5. EXTRA ELECTRIC OUTLET

CAUTION ; Never unplug heater while heater is running

Heater must go through cooling cycle. The cooling cycle cools the

combustion chamber. Damage to heater can occur if combustion chamber

is not cooled. Do not restart heater until cooling cycle is complete.

COVER

ELECTRIC OUTLET

Always cover electric outlet when not in use.

Do not plug in and use an appliance of more than 120V 5A current in this outlet.

WARNING ; SHOCK HAZARD!

CAUTION ; Do not restart heater until cooling cycle is finished.