Seaward ARE 1557 - Manual (Page 21)

ERT1557
Operating Instructions
- 21 -
7.1.5 Identify the COM port associated with CP210x
USB to UART Bridge Controller. This is COM4,
in the example shown.
7.2 Hyper Terminal Setup Procedure
7.2.1. Install the USB driver provided as part of the
supplied accessories on a PC (Depending on
the computer operating system).
7.2.2 Some computer operating systems are not
supplied with the hyper terminal program. In this
case the program can be downloaded free from
the internet.
7.2.2 Open the hyper terminal communications
program on the PC (Path:-start / All Programs /
Accessories / Communications / HyperTerminal).
7.2.3 Enter the name of the hyper terminal connection
e.g. ERT Download. Click on the OK prompt
softkey and select the appropriate COM port to
which the USB is connected. Click on the OK
prompt softkey.
7.2.4 Hyper Terminal configuration port settings are:-
Baud Rate 4800 Bps
No of Data bits 8
Parity None
Stop bit 1
Flow Control None
Click on the OK Prompt softkey.
7.2.5 The following screen is displayed on the PC
monitor.