Scotsman NDE554 - Manual (Page 24)

REMOVAL AND REPLACEMENT
WATER RESERVOIR
1. Shut off the water supply to the icemaker.
2. Remove front panel and reservoir cover.
3. Disconnect inlet water line from valve.
4. To remove just the float, push the locking tab at
the back of the valve mounting block in and lift the
valve and block up and out of the reservoir tank.
Note: inside the valve, there is a plunger which
may be replaced separately, if desired.
5. To remove reservoir, remove drain hose from
reservoir.
6. Remove evaporator inlet hose from reservoir.
7. Remove mounting screws from reservoir
bracket, and remove reservoir from icemaker.
8. Reverse to reassemble.
BIN CONTROLS (Ice Level Sensors)
1. Disconnect electrical power.
2. Remove front panel.
3. Remove control box cover.
4. Locate bin top, in front of and behind it are two
rubber bin control grommets.
5. Pull each bin control out, and in the control box,
disconnect the electrical leads connecting the bin
control to the circuit board.
6. Reverse to reassemble, be certain that the bin
controls are aligned so that the ice level sensors
are visible (centered) through the holes in the ice
chute.
NDE554 & NDE654
March 2000
Page 24
BIN CONTROLS
GROMMETS
BIN TOP
FLOAT
ASSEMBLY
LOCKING
TABS
Water
Sensor