Scotsman NDE554 - Manual (Page 14)

OPERATION: Water
Water enters the machine through the 3/8" male
flare at the rear of the cabinet, goes to the water
reservoir which it enters through the float valve.
The water then goes out the bottom of the
reservoir tank to the bottom of the evaporator.
Reservoir overflow, evaporator condensation, bin
drainage and water from the sink are all routed to a
common drain. Water cooled models have a
separate water circuit for the cooling water: it
enters the fitting at the rear, goes to the water
regulating valve, then to the water cooled
condenser and down the drain.
There is also an additional water circuit to an
electric valve. When the water station glass filler
lever is pushed, a switch closes a circuit to the
electric water valve, and water is dispensed.
NDE554 & NDE654
March 2000
Page 14
WATER RESERVOIR
WATER INLET
WATER DRAIN
WATER LINE FOR
WATER STATION
WATER
LEVEL
Note: The correct water level is determined when
the machine is operating. Check the water level and
compare it to the line molded into the side of the
reservoir. The water level should be between 1
8
“
above and 1
4
" below the line.
If needed, adjust the water level by bending the
float arm.