Scotsman FDE474 - Manual (Page 5)

For The Plumber
Drains:
The dispenser requires a gravity drain. The pitch
on the drain tubes must be at least 1/4 inch fall per
foot of horizontal run. On long horizontal runs, a
vent at the back of the cabinet will improve
draining, and is recommended.
There are two drains to connect: A sink drain, a 7
8
“
plastic tube; and the bin drain, a 5
8
” plastic tube.
Install rigid tubing between the machine and the
building drain. Route the drains separately to the
building drain.
Water supply:
Connect cold, potable water to the machine. A
hand valve near the location is recommended. A
water filter is also a good idea.
Follow all local codes.
FDE474
March 2000
Page 5
FOLLOW ALL APPLICABLE LOCAL, STATE
AND NATIONAL CODES
Strainer or
Filter
Water Inlet Fitting
(Inside Cabinet)
Sink Drain
Bin and Reservoir
Overflow Drains
Water Supply
Building Drain
(Typical)