beautypg.com

Fde474, Sanitation and cleaning, Maintenance – Scotsman FDE474 User Manual

Page 16

background image

Maintenance:

Although the ice in this dispenser is completely

untouched, the water and ice vending systems will

need to be periodically sanitized and

de-mineralized. The air cooled condenser will also

need to be kept clean.

Schedule the sanitation, cleaning and

de-mineralization on a regular basis to keep the ice

clean and the machine operating efficiently.

Sanitation and Cleaning

Water System:

This ice machine requires periodic sanitation and

de-mineralization.

1. Vend all ice from the machine.

2. Remove top and right side panels.

3. Unplug or disconnect electrical power.

4. Shut off water supply.

5. Drain reservoir.

6. Mix 8 ounces of Scotsman Ice Machine Cleaner

and 3 quarts of hot (95

o

F. -115

o

F.) potable water.

7. Pour the water into the reservoir.

8. Wait 15 minutes for the cleaner to dissolve the

minerals inside the evaporator.

9. Plug in the machine or reconnect electrical

power.

10. As the machine operates, pour in the balance

of the cleaning solution.

11. Reconnect water supply, operate the machine

for 15 more minutes, then switch it off.

12. Repeat steps 3-11, except substitute a locally

approved sanitizing solution for the cleaner. A

possible sanitizing solution may be obtained by

mixing 1 ounce of household bleach with 2 gallons

of clean, warm (95

o

F.-115

o

F.) water.

13. Unplug or disconnect electrical power.

14. Remove bin top, pour in warm potable water to

melt out any ice.

15. Pull out the vane and bin bottom from the bin.

16. Thoroughly wash the bin’s interior, bin top

interior, spout, ice vane and bin bottom with the

sanitizing solution. Pour some down the bin drain.

17. Reassemble the bin bottom, vane and bin

cover.

18. Wash the sink area with the sanitizing solution

and pour sanitizing solution down the sink drain.

19. Replace all panels and reconnect water and

electrical power.

Air Cooled Condenser:

1. Disconnect electrical power.

2. Remove top panel

3. Remove right and left side panels.

4. Use pressurized air to blow the lint from the

outside of the condenser in towards the fan motor.

A vacuum cleaner hose placed on near the fan

motor should pick up most of the dust. Check for

interior dirt. If needed, use coil cleaner to

de-grease the condenser.

5. Replace all panels and reconnect electrical

power.

FDE474

March 2000

Page 16

Scotsman Ice Machine

Cleaner contains acids.

These compounds may

cause burns.

If swallowed, DO NOT

induce vomiting. Give

large amounts of water or

milk. Call Physician

immediately. In case of

external contact, flush

with water.

KEEP OUT OF THE

REACH OF CHILDREN.

This manual is related to the following products: