Scotsman CB0522 - Manual (Page 36)

Network Configuration
Used only when connected to a network. There is an Ethernet connector on the
back of the Information Display board. If desired, route a network cable thru the
cabinet and connect your network to it.
To view or change the Network Configuration, use the up and down arrow keys
to display Network Configuration. When the N in Network is underlined, press
and release the Enter key.
The IP address (if connected to a network) will be displayed. If not connected
to a network, "Please Wait" will be displayed.
Press the down arrow key to see the Subnet Mask
Press the down arrow key to see the Default Gateway
Press the down arrow key to see the DNS
Press the down arrow key to see DHCP Enable
Press the down arrow key to see the Update IP Address screen. Press the SEL
key to access it.
Press the up or down arrow key to change the first (underlined) number. Press
the SEL key to move the underline to the next number, then press the up or
down key to change that number. Repeat as needed to change the numbers.
When done, press the Enter key.
Repeat the same process to change the other network parameters, if needed.
Once desired network parameters have been manually configured, turn on
“Update Network on Next Power Cycle”. After the power to the machine has been
cycled, the new parameters will take affect.
August 2011
Page 36
CB0522 through CB1030
Information Display
IP Address
Subnet Mask
Default Gateway
DNS
DHCP Enable
Update IP Address
Set Update IP Ad
PGM Bin Level
Network Configu