Scotsman CB0522 - Manual (Page 13)

Adjustments
Bridge Thickness - For the Service Tech Only
1. Push and hold Off till the machine stops.
2. Remove evaporator cover.
3. Remove curtain.
4. Use a hex wrench and rotate the bridge
thickness adjustment screw in 1/8 turn
increments CW to increase bridge thickness.
Rotate CCW to decrease bridge thickness.
Caution: Do not make the bridge too thin or the
machine will not harvest properly. Bridge thickness
adjustments are not covered by warranty.
5. Return curtain and evaporator cover to their
normal positions.
6. Push and release the On button. Check next
harvest of ice. Repeat steps 1-6 if needed.
Water Purge Setting
The water purge is factory set to the automatic
position, suitable for most water conditions. The
setting can be changed to one of 5 manual settings
or left on automatic.
Purge
setting
1 - Minimum
2 -
Moderate
3 - Standard 4 - Heavy 5 - Maximum A - Automatic
Water
Type RO water or
equivalent
Low TDS
non - RO
water
Use for
typical water High TDS
water Very High TDS
water
Any with
conductivity not less
than 10
microSiemens/cm
To set:
1. Switch the machine OFF by holding the Off
button in until a number or the letter
A shows
on the display.
2. Press and release the On button repeatedly
until the number on the display corresponds to
the desired setting.
3. Press and release the Off switch again to
return to the normal control state.
August 2011
Page 12
CB0522 through CB1030
Air Cooled User Manual
Bridge Thickness Adjustment Mechanism
Ice Bridge Thickness Measurement
Adjustment
Screw
Too Big Too Small Just Right
1/8-3/16"
bridge