DTS RV4700 DTS-ES - Manual (Page 30)

30
DIGITAL AUDIO RECORDING WITH MD RECORDER
For digital recording, select the desired
digital input as recording signal input.
2
Select a desired input of CD, TAPE
MONITOR and VIDEO 1~VIDEO 4 as a
recording source.
1
Start recording on the component
connected to OPTICAL DIGITAL OUT.
3
• Only when the OPTICAL DIGITAL OUT of this receiver is connected to the OPTICAL DIGITAL IN of the MD recorder or CD
recorder, you can enjoy high-quality sound of digital recording without converting the original signals. Refer to “CONNECTING
AUDIO COMPONENTS” and “CONNECTING DIGITAL INs and OUT” on page 5 and 7 and the operating instructions of the
MD recorder or CD recorder.
Notes:
• Digital recording is available for the digital audio program sources such as CDs, MDs, some DVDs, etc.
• In most DVDs as well as some CDs, etc., digital recording may not be available depending on the signal format.
• There are some restrictions on recording digital signals. When making digital recordings, refer to the operating instructions of
your digital recording equipment to know what restrictions are imposed.
or
INPUT SELECTOR
AUDIO VIDEO TAPE MON.
DVD
VOL. CH LEVEL
CH SEL
DSP MODE
AUTO
ST CENTER MODE TEST TONE DISC P.SCAN
TUNER CD T1/MON AUX PHONO
VID1 VID2 VID3 VID4 VID5
SYS DISP SLEEP DIRECT IN ROOM2
INTRO
RETURN
B RPT A
7.1 SURR TITLE
ENTER
CD T1/MON
VID1 VID2 VID3 VID4
HOME THEATER MASTER RV4700 DTS-ES
Start play on the desired input.
4
• Each time this button is pressed, the corresponding
input is selected as follows:
DIGITAL ANALOG
Note: When the selected digital input is not
connected, “DIGITAL” is flickering, meaning
no recording as well as no sound.
DIGITAL/ANALOG
Start recording on the VIDEO 1.
3
Start play on the VIDEO 2 and the CD
respectively.
4
• The audio signal from the CD and the video signal
from the VIDEO 2 will be dubbed and you can
enjoy them on the TV set and from the speakers.
Note: Be sure to observe the order of the above
steps and .