How to do customized output resolution, How to program the input signal, How to realize single image switching – RGBLink VSP 5162PRO User Manual

Page 8

Address：S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C

Tel: 00865925771197 Fax:00865925771202

Email: [email protected] http://www.rgblink.cn

FORMAT>, push the [SEL] button to confirm.

2. Push the [UP/DOWN] button and choose [CUSTOMIZED], push the [SEL] button to confirm.

3. Push the [SEL] or [LEFT/RIGHT] button, and choose the position that need to adjust. Then push the

[UP/DOWN] button to adjust the width.

4. Same operation for height and rate.

5. After adjust all the values, push the [SEL] button to enable VSP 5162PRO to output this resolution.

1. Push any button of [1], [2], [3], [4] in Preview area, and choose the input signal.

2. Push [PRO] button, then finish the input signal program.

Note: If choose the same signal in Program and Preview area, the signal can not be programmed.

VSP 5162PRO can realize seamless effects switch between two channels, choose the signal in

Preview area, then push [CUT] or [TAKE] button, the signal will be switched to LED display.

For example, switch the signal of channel 2 to LED display, first push the [2] button in Preview area,

then push the [CUT] or [TAKE] button, and the LED display will show channel 2 signal.

System default the switch time is 1 seconds for [TAKE] button, if need to adjust the fade in fade out time,

push the [FADE] button, then push the [UP/DOWN] or [LEFT/RIGHT] button for setting, and push the

[SEL] button to confirm. Push [TAKE] button again, the signal will be switched to the LED display with