beautypg.com

How to do customized out, How to realize single image, How to do customized output resolution – RGBLink VSP 112U User Manual

Page 9: How to realize single image switching

background image

Address:S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone Xiamen,Fujian Province, P.R.C

Tel: 00865925771197

Fax:00865925771202

Email: [email protected]

http://www.rgblink.cn

8

How to Do Customized Output Resolution

1. Push [MENU] button to enter the menu items, turn the knob and go to , push

the knob and confirm to go into the menu.

2. Push the knob and go into menu.

3. Turn the knob on each digital position, and change the value of the digital by the digital buttons on the

front panel.

4. After the digital, push the knob will add ×, means before the × is the horizontal size. Same operation

for vertical size.

5. After the digital, push the knob will add @, means before the @ is the vertical size, and after the @ is

the refresh rate. Only digital 50 or digital 60 supports for the refresh rate. Use the digital buttons to

finish the settings.

6. After input all the values, push knob to enable VSP 112U to output this resolution. VSP 112U will

take 5 to 10 seconds to enable this output resolution.

How to Realize Single Image Switching

1. Boot the system default CV1 to the current input source, if need seamless switching other source

such as DVI, push the DVI button.

2. CV1 button light turns off after pushing DVI button. DVI button light is on if the DVI signal is effective

and stable. And if the DVI signal is invalid or no input, DVI button light will flash.

Note: Seamless switch means signal switch will not appear any flash point, black, shaking or delay.