Rena T-350 - Manual (Page 36)

MAINTENANCE
Section 5 – Maintenance
This section describes maintenance that an experienced operator can perform. If service
or maintenance is needed, beyond what is described in this document, please contact your
local Rena Systems Dealer to obtain service and support for your tabber.
Service should only be performed by a qualified Rena service person.
To locate a Rena Systems Dealer in your area, please use the following link.
http://www.renausa.com/dealer_locator_search.asp
Cleaning
WARNING
BEFORE PERFORMING ANY MAINTENANCE, DISCONNECT THE
TABBER FROM ITS POWER SOURCE!
In order to help maintain proper function; the tabber must be cleaned regularly. Unplug
the tabber from the wall outlet before cleaning...
The frequency of cleaning will depend on the amount and type of media being run
through the tabber. A tabber that is used less frequently may only need to be cleaned once
a week. A tabber that is being used heavily, or being used with media that contains a lot
of dust or ink residue, may need to be cleaned more than once a day.
The visible areas are best cleaned with a vacuum that has a soft brush attachment to help
loosen the dust particles.
Tabber Body
The covers of the machine may be cleaned with any standard household cleaner, which is
non-abrasive and does not contain plastic harming solvents.
CAUTION
NEVER SPRAY OR POUR CLEANERS DIRECTLY ON OR INTO
THE TABBER. EXCESS LIQUID COULD HARM ELECTRONIC
PARTS. ALWAYS DAMPEN A RAG WITH THE CLEANER AND
APPLY IT TO THE PARTS TO BE CLEANED.
36 T-350 Operations Rev. 3/23/2009