Rena T-350 - Manual (Page 22)

OPERATING THE TABBER
9. Bring the tab backing up around the back side
of the Take-Up Spools and insert the end of the
leader into the slit, in the spool.
Tip: Creasing the tab backing, at the insert
point, will help it hold onto the spool.
10. Advance the Take-Up Spool, until you have
removed the slack in the leader.
Tip: To prevent the tab backing from
slipping off the spool, you need at least one
complete wrap of tab backing around the
spool.
11. Re-verify that the hole, in center of the first tab on the
leader, is still aligned with the red dots at the inside
edges of the tab drive assembly.
IMPORTANT! When the peel bar is in its upper
position (threading position); the red dots, at the inside
edges of the tab drive assembly, should align with the
hole in the center of the first tab. Verify that this
alignment is correct, before you continue.
T-350 Operations Rev. 3/23/2009 22