Rena T-350 - Manual (Page 30)

OPERATING THE TABBER
Adjusting the Tab Position
Horizontal Tab Positioning
The desired horizontal tab position is obtained by sliding the Tab Drive Assemblies to the
desired position.
1. If the TAB button is illuminated; turn it off by pressing the TAB button.
2. Set the speed control dial to minimum. Feed a single piece of media into the
tabber and stop it as it is just starting to travel under the exit rollers, as shown.
This can be accomplished by pressing the FEED button to start feeding the media,
then quickly pressing the FEED button again to stop feeding the media.
It may take a few tries to get a piece of media to stop as it just starts to exit the
tabber.
3. Slide the Tab Drive Assemblies to the
desired tab position. The black roller,
located at the bottom of the tab drive
assembly, can be used to approximate the
location that the tab will be applied to the
media.
4. Adjust the positions of the Take-Up
Spools so they are aligned above the Tab
Drive Assemblies.
T-350 Operations Rev. 3/23/2009 30