Remotec ZXT-120 V1.1 - Manual (Page 4)

4
ZXT‐120 into their Z‐Wave network using the primary controller. Then,
the user can use either the primary controller or secondary controller
to configure and setup the ZXT‐120 using Z‐Wave’s configuration
command class. Once the configuration and setup is complete, the
controller can use Z‐Wave “Thermostat commands class” to control
their IR‐controlled air‐conditioner through the ZXT‐120.
Controller and Gateway Requirements
The ZXT‐120 can work with any Z‐Wave compliant controller or
gateway supporting the following Z‐Wave commands.
-
Configuration Command Class
- Multilevel Sensor Command Class
-
Thermostat Command Class
ƒ
Thermostat Mode Command Class
ƒ Thermostat Fan Mode Command Class
ƒ
Thermostat Set‐point Command Class
Built‐in IR code library
The Built‐in IR code library supports most of the popular air
conditioner brands in the market. Z‐Wave gateway and controller
does not need to have any IR control code knowledge. User can use Z‐
Wave controller or gateway to select the IR code according to the ZXT‐
120 code list separately provided through Z‐Wave configuration
command.