Remotec ZXT-120 V1.1 - Manual (Page 17)

17
Reset ZXT‐120 to factory default
Press and hold “PROG” button for 10seconds on ZXT‐120. The LED will
flash twice until reset process is completed.
Note: This reset step will not affect the operation mode of ZXT‐120,
user should refer to
“ Listening Mode ＂ section if you want to change
the operation mode.
L Information
− If you are using Gateway or other Z‐wave controllers to
operate ZXT‐120, Please follow the instruction from the
gateway or other controller.
− You can check either the specifications in the manual of your
ZXT‐120 or also check online at www.remotec.com.hk for a
full list of products that can be used with your ZXT‐120.