Remotec ZXT-120 V1.1 - Manual (Page 12)

12
1
After included ZXT‐120 to Z‐Wave
controller or Gateway, go to device
setup for configuration on gateway
or controller. ‐
2
Input parameter number “27” and
parameter value (please look up the
code list of ZXT‐120 according to
your AC brand). Then complete the
configuration process. ‐
3
Press the PROG button on the ZXT‐
120. (this step apply when using
ZRC‐100 or other portable controller
for set up, if using gateway, user can
skip this step)
• LED flashes once
when ZXT‐120
receives the
configuration
setting
4
Go back to the control page of ZXT‐
120 on the gateway and try the
function such as (cool, temperature
set).
If the air conditioner does not
respond to the command you set on
Gateway (Cool, Heat, Auto,
Temperature set etc.), repeat step 2
and 3 to select the next code on
code list.
• LED flashes once
every time it
receives a
command from
gateway
L Important Information
− Different brand or model of air conditioner has different
function. For example, some air conditioner only support
temperature set from 18
o
C‐30
o
C, if user set 17
o
C on gateway,
ZXT‐120 will not respond.
− There are more than 1 code for each brand, some does not
support heat, if user selected a code that does not support
heat but the original air conditioner supports heat function,
please continue to try next code until the correct one is
selected.
− If none of the code works on the target air conditioner, or the
air conditioner brand is not shown on the code list, please
select code “000” for IR code learning (refer to instruction of
IR Code Learning)