REMKO FBR-2 - Manual (Page 6)

6
REMKO FBR-2
ANALOGUE REMOTE CONTROL
WITH ROOM SENSOR
Operation
Two rotary knobs are located on the
front side of the remote control with
room sensor. The left-hand rotary knob
is a switch that can be used to set the
mode. The following modes can be
selected:
1 Automatic mode (operates according
to time programme 1 in controller)
2 Automatic mode (operates according
to time programme 2 in controller)
24 hour night programme
(Decreasing temperature)
24 hour daytime programme
(Comfort temperature)
Summer mode (Heating OFF, only
hot water)
Rotary knob for
adjusting the
nominal room tem-
perature
Rotary knob for
mode selection
The mode on the heat pump manager
must be set to "Automatic 1".
NOTE
The right-hand rotary knob can be used
to set the nominal room temperature.
The adjustment range is ± 5K from the
programmed room temperature on the
heat pump manager. There is a tolerance
of ± 2K.
Nominal room temperature according to
programming on heat pump manager
Nominal room temperature around
5 K warmer than programming on
heat pump manager
Nominal room temperature around
5 K warmer than programming on
Heat pump manager