REMKO DN 32 - Manual (Page 8)

8
REMKO
3-WAY SWITCHING VALVE DN32
Manual mode
The 3-way switching valve can be
operated manually until the time of
commissioning or in case of a defect of
the actuator. The electrical actuator must
be removed in this case.
The replacement of the actuator
must take place in a de-energised
(electrical) state. Also disconnect the
main connection to the actuator.
To do so, proceed as follows:
1. Loosen fastening screw "2" of the
actuator. This is under the black
cover. Then you can remove the
actuator.
Removal of the actuator
Removal of the actuator
2
2. The 4-way switching valve can
be moved to the desired position
using a large screwdriver. This
must be able to take place
smoothly and easily. Otherwise the
valve must be replaced, cleaned
and/or repaired.
Manual mode
ATTENTION