REMKO RKS 435 H - Manual (Page 16)

Test run
1.� Remove the �over�� from the Remove the �over�� from the
valve��.�
2.� Start initial operation by briefly Start initial operation by briefly
opening the blo�king valve��
on the outdoor unit until the
manometer indi�ate�� a pre����ure
of approx.� 4 bar.�
3.� Che�k all �onne�tion�� for leak�� Che�k all �onne�tion�� for leak��
u��ing leak dete�tion ��pray or
appropriate equipment.�
4.� �f you have identified any leak��, �f you have identified any leak��,
open the blo�king valve�� by
turning them a�� far a�� po����ible
anti�lo�kwi��e u��ing a hexagonal
wren�h.�
�f leak�� are identified, the
defe�tive �onne�tion ��hould be
repla�ed.� �t i�� then e����ential to
�t i�� then e����ential to �t i�� then e����ential to
repeat va�uum generation and
drying.�
5.� Turn on the on-��ite ma��ter Turn on the on-��ite ma��ter
��wit�h or fu��e.�
6.� Set the target temperature on Set the target temperature on
the indoor unit to a lower tem-
perature than the �urrent room
temperature u��ing the remote
�ontrol.�
7.� Swit�h the indoor unit to �ool- Swit�h the indoor unit to �ool-
ing mode.�
9.� Che�k the �ontrol of the indoor Che�k the �ontrol of the indoor
unit u��ing the fun�tion�� de-
���ribed in the operating manu-
al:
timer, temperature ��etting�� and
all mode ��etting��.�
10.� Mea��ure overheating, the
external, internal, outlet and
evaporation temperature�� and
enter the mea��ured data in the
initial operation log.�
11.� Remove the manometer and
re-atta�h all part�� previou��ly
removed.�
Make ��ure that the ��eal�� are
fitted in the �over��.�
Final measures
■�
Re-fit all part�� removed.�
■�
�n��tru�t the operator in how to
u��e the ��y��tem.�
8.� During the te��t run, �he�k the During the te��t run, �he�k the
fun�tion and �orre�t ��etting
of all regulating, �ontrol and
��afety devi�e��.�
Dimen��ion�� and de��ign ��ubje�t to modifi�ation�� in the �our��e of te�hni�al development.�
Unit dimensions
Because of the start-delay, the
compressor starts running a
few minutes later.
NOTE
540 120
850
285
540
RKS H / RKS 8H
All figure�� in mm
290
770
REMKO RKS
1