REMKO RKL 300 - Manual (Page 9)

4 Operation
The system can be operated by means of the control panel on the unit or via the standard infrared remote
controller. The functional operation of the keys among themselves is identical, however, the designation can
vary. The batteries must be correctly inserted before the infrared remote control is used.
9
1
10
11
12 13
14 2 3
4 5
6
8 7
Fig. 3: Control panel
Legend
1 Key "I/O" (On/Off)
This key switches the unit on or off.
2 Operating mode "MODE" key
The actuation of this key allows the operator to
select between one automatic and three manual
fan stages in cooling mode (AUTO, HI, MED, LO)
or between recirculating mode (FAN). The LEDs
on the display 8 show the stage selected.
Adapted fan stages:
LED „AUTO“
Largest fan stage:
LED „HI“
Medium fan stage:
LED „MED“
Smallest fan stage: LED „LO“
With "AUTO" selected and with a large difference
between the target room temperature set and the
current room temperature, a high fan stage will be
automatically selected. Conversely, with a small
difference a small fan stage will be automatically
selected.
3 "AUTO SWING" key
The distribution of the air emerging from the unit
can be set with this key.
1. Key press = Continuous swing function
2. Key press = Swing function stopped
3. Key press = Continuous swing function
4 "▲/▼" keys "THERMO CONTROL"
By actuating the "▲/▼" keys the display changes
to the programmed target temperature. This can
be adjusted in a range of 18 to 30 °C in 1°C steps.
5 "SET TIMER" key
The automatic switching on or off of the unit can be
activated with this key. When switched off the
switch-on timer can be programmed in 1-hour
steps up to 24 hours with the "SET" button. The
same applies to the switch-off timer when the unit
is switched on. The LEDs 10 and 11 indicate the
activation.
Temperature/time adjustment
6 "RESET TIMER" key
The programmed timer can be cleared by
actuating the "RESET" 6 key.
9