REMKO RKL 300 - Manual (Page 11)

Inserting the batteries into the remote control
Before initial commissioning, insert the supplied
batteries (2 each, type AAA) into the remote con-
trol.
1. Slide the battery compartment cover on the rear
of the remote control to open it.
2. Insert the batteries with the correct polarity.
Observe marking in the battery compartment.
3. Close the battery compartment again.
Functions of the infra-red remote control
All settings of the unit can be implemented via the
remote control supplied. Please refer to the "Con-
trol panel" section for the functions of the keys.
The range of the remote control is ca. 5 metres.
2
1
5
3
15
4
6
Fig. 4: Infrared remote control
1: On / off "POWER" key
2: Operating mode "MODE" key
3: "AUTO SWING" air distribution key
4: "TIMER SET" timer key
5: "TIMER RESET" timer key
6: "▲/▼" keys "THERMO CONTROL"
15: Infrared transmitter
Help save on energy consumption in stand-by
mode! If the device, system or component is
not in use, we recommend disconnecting the
power supply. Components with a safety func-
tion is excluded from our recommendation!
11