Quintum Technologies Tenor Call Relay 60 - Manual (Page 55)

P/N 480-0076-00-00 6-4
Chapter 6: Diagnostics/Maintenance
Ping Unit
Ping enables you to ping an IP address. See Chapter 4: Getting Started with Configuration for more
information.
Monitor Alarms
Alarms
Alarms help you identify where a specific problem is occurring with the Call Relay 60 unit. Through
the CLI, you can review alarms via Command Line Interface (CLI). Verify all severity 1 alarms
first; these alarms indicate that the unit is in critical condition and the entire system is affected.
See Chapter 5: System Alarms for specific information about obtaining and reading alarms.
General Maintenance
Restore Factory Defaults
You can set all system configuration settings back to their factory defaults via Command Line Inter-
face (CLI) as follows:
1. Access the CLI through a Telnet session. See Chapter 4: Getting Started with Configuration for
more information.
2. Access the config# prompt.
3. Type setfactory. You will be asked if you are sure you want to set the unit back to factory
defaults.
4. Type yes to confirm (type no to cancel the restore).
Reset System
1. Access the CLI through a Telnet session. See Chapter 4: Getting Started with Configuration for
more information.
2. Access the Maintain-MasterChassis-1# prompt.
3. Type reset. The unit will be reset.
Change Password
For security purposes, you may want to change your password. You can change the password via
Command Line Interface (CLI) as follows:
1. Access the CLI through a Telnet session. See Chapter 4: Getting Started with Configuration for
more information.