Connect to pc console, Connect to pc console -7 – Quintum Technologies Tenor Call Relay 60 User Manual
Page 34
P/N 480-0076-00-00
3-7
Chapter 3: Installation
Connect to PC Console
You will need to connect the Tenor Call Relay 60 to your workstation’s serial port via RS-232 con-
nection. (This connection will be used when you assign an IP address to the unit.) For the instruc-
tions below, it is assumed you are connecting to a Windows PC.
Figure 3-5
DB-9
Connect to PC Com Port
1. Insert the male end of the DB-9 cable into the port labeled Console. (See
for RS-232 connector pinouts.)
2. Insert the female end of the DB-9 cable into your workstation’s serial port (see your PC docu-
mentation for more information about this port).