Quantum Composers 9530 Series - Manual (Page 62)

Page 62 9530/8530 Manual Version 4.8

The recommended connector is Molex 4 pin female C-grid (Molex #50-57-9404) or
equivalent.

The recommended contacts are Molex female terminals with gold contacts (Molex #16-
02-0087) or equivalent.
Pin Number:
Connection: Specification:
1 (denoted by arrow on connector) +5 Volts DC 5V±2%, 1.2 Amp nominal capability
2 Ground
3 Ground
4 +24 Volts DC 24V±6%, 0.8A nominal capability
*Note: For an additional cost a recommended power supply and cable can be supplied
Power Switch Connector (J4 – Pwr_Enab)

The recommended connector is Molex 2 pin female C-grid (Molex #50-57-9402) or
equivalent.

The recommended contacts are Molex female terminals with gold contacts (Molex #16-
02-0087) or equivalent.
*Note: This is the power enable switch; Short the contacts to turn the unit on and open them to
power down. (This connector will come shorted)
External Clock Input (J6)

The recommended connector is a male BNC
Internal Clock Output (J15 and J16)

The recommended connector for J16 is a male BNC

The recommended connector for J15 is a Molex 2 pin female C-grid (Molex #50-57-
9402 ) or equivalent.

The recommended contacts for J15 are Molex female terminals with gold contacts
(Molex #16-02-0087) or equivalent.
Pin Number:
Connection:
1 (denoted by arrow on connector) Clock Out
2 Ground
Output Board Connection (Mini PCB Card Edge)

This card edge must be connected to either J1 or J2 on the Output Board