Appendix e - dual trigger input, Dt15, Rigger – Quantum Composers 9530 Series User Manual
Page 54: Odule, 9530 scpi dual trigger command summary, Dt15 dual trigger module
Page 54
9530/8530 Manual Version 4.8
generator and communication hardware are functioning properly. From here, a specific
application in whatever preferred programming language can be built.
Although Quantum Composers cannot support all programming languages, we do have extensive
experience with many languages, and strive to provide whatever assistance we can. Contact QC
technical support for the latest information on what assistance may be available for your
application.
12. Appendix E - Dual Trigger Input
DT15 Dual Trigger Module
*Note: Dual Trigger Mode and Incrementing mode are mutually exclusive.
This module option allows the
“Gate” input to function as a second trigger input. For consistency,
the enabling menu for this option is located under the
“Trig” menu structure. Once the dual trigger
mode is enabled, both the
“Gate” and “Trig” inputs can act as trigger inputs.
Adjustments for the
“Gate”
functioning
as a trigger input are located under the
“Gate” menu
structure. The voltage threshold level and trigger edge for the
“Gate” input can be adjusted from this
menu. The
“Gate” trigger edge choice is only available when
in dual trigger mode.
Once dual trigger functionality is enabled on the unit, each channel can be assigned to either of the
trigger inputs. The default trigger source for each channel is the
“Trig” input. The trigger source
selection is accessed in the secondary channel menus. To access this menu, press the button for
the channel of interest twice. Continue to press then the Page
button until the menu page with
“Ch
Gate:
” and “TrigSrc:” appears. Use the “Next” button to place the cursor on the “TrigSrc” line and
use the up/down arrows to change to the desired trigger source.
9530 SCPI Dual Trigger Command Summary
Keyword:
Command:
Sub-
Command:
Parameter Range:
Notes:
:PULSe[0]
Command to change the units’ global settings,
this is the same as using the :SPULse
command
:TRIGger
Command to change the units’ global trigger
settings.
:MODe
DIS / TRIG / DUAL
Sets the unit to dual trigger mode.
:PULSe[1/2/n]
Command to change the units’ channel
specific settings.