Quantum Composers 9530 Series - Manual (Page 59)

9530/8530 Manual Version 4.8 Page 59
Ch: -HGFE DCBA-
Mux: -0000 0001-
Enable/Disable Channel
IncW: Set the Incrementing Width
IncD: Set the Incrementing Delay
P
re
ss
th
e
P
ag
e
B
u
tto
n
Using the Duty Cycle Increment Function

In the System Mode menu:
o Set the mode to DCIncrement mode.
o Set the number of on and off pulses that are desired.
o Press the Page button and set the number of cycles to run.
o Set the T
0
period.

In the Channel menu:
o Set the desired pulse width and delay.
o Set the desired Channel Mode.

In the Channel Advanced menu:
o Set the desired width increment step size.
o Set the desired delay increment step size.

Via a serial interface send the :PULSe0:IRESet 1 command to initialize the incrementing
mode
Once the Run/Stop button is pressed the unit will generate one set of pu
lses, ‘N’ on and ‘M’ off.
Pressing the Run/Stop button again will generate a second set of pulses with the width and delay
adjusted by the increments set in the Channel Advanced menu. To reset the width and delay
increments the :PULSe0:IRESet 1 command must be sent to the unit using
HyperTerminal.
Using the Burst Increment Function

In the System Mode menu:
o Set the mode to BurstIncrement mode.
o Set the desired number of pulses.
o Press the Page button and set the T
0
period.

In the Channel menu:
o Set the desired pulse width and delay.
o Set the desired Channel Mode.

In the Channel Advanced menu:
o Set the desired width increment step size.
o Set the desired delay increment step size.

Via a serial interface send the :PULSe0:IRESet 1 command to initialize the incrementing
mode
Once the Run/Stop button is pressed the unit will generate one set of pulses. Pressing the
Run/Stop button again will generate a second set of pulses with the width and delay adjusted by
the increments set in the Channel Advanced menu. To reset the width and delay increments the
:PULSe0:IRESet 1 command must be sent to the unit using
HyperTerminal.