Quantum Composers 9530 Series - Manual (Page 41)

9530/8530 Manual Version 4.8 Page 41
Keyword: Command:
Sub-
Command:
Parameter Range: Notes:
:PULSe[1/2/n]
Command to change the units’ channel
specific settings.
:CGATe DIS / PULS / OUTP
Sets the channel gate mode to Disabled,
Pulse Inhibit mode, or Output Inhibit mode.
*Note: The system global gate mode must be
set to CHAN for this command.
:CLOGic LOW / HIGH
Set the channel gate to active LOW or active
HIGH.
*Note: The system global gate mode must be
set to CHAN for this command to work.
Keyword: Command:
Sub-
Command: Sub-
Command:
Parameter Range: Notes:
:SYSTem
Command to change the units’
system settings.
:STATe ? Query Only Command
:BEEPer
Command to change the units’
beeper settings.
:STATe 0/1 or OFF/ON
Command to turn on or off the
systems' beeper.
:VOLume 0 - 100
Command to change the units'
beeper volume.
:COMMunicate
Command to set the
communication settings.
:SERial
Sub-Command to set the serial
interface parameters.
:BAUD
4800 / 9600 / 19200 /
38400 / 57600 /
115200
Command to change the baud
rate for the RS-232 interface.
:USB
4800 / 9600 / 19200 /
38400 / 57600 /
115200
Command to change the baud
rate for the USB interface.
:ECHo 0/1 or OFF/ON
Command to Enable/Disable
the echo function on the RS-
232 interface. The Echo
function will cause the unit to
repeat the command received
to the PC.
:KLOCk 0/1 or OFF/ON
Command to lock-out the
keypad.
:AUTorun 0/1 or OFF/ON
When the unit is powered up, if
this command is enabled, the
unit will start pulsing
automatically.
:VERSion ?
Query only. Returns SCPI
version number in the form
YYYY.V for ex. 1999.0
:SERNumber ?
Query only. Returns the serial
number of the unit. The format
returned will be “SER# xxxxx”.