PSE Archery Bow 2014 - Manual (Page 7)

Compound Bow
USER’S GUIDE
PAGE
7
pse x technoloGy
PSE X Technology bows come with many unique features that will enhance your
archery experience.
uSING A BOW PRESS WITH X TECHNOLOGY BOWS
ALL PSE X Technology bows MuST be serviced in an approved bow press and require special
consideration. Do not attempt to service these bows in any bow press without reviewing the
procedures described herein.
Use of a non-approved bow press or improper use of an approved bow press WILL result
in damage to the bow and possible personal injury. Damages incurred by improper use
or maintenance will not be covered under the warranty. See the PSE website at
www.pse-archery.com for a list of approved bow presses.
There are two basic types of approved presses available: compression-type
and pull-type. (Pg8)
COMPRESSION-TYPE BOW PRESS:
This type of press pushes in a horizontal direction against the tips of the limbs.
No other support for the bow is required.
When using a press of this type, back each limb bolt out the maximum number of turns
indicated on your bow’s hang tag. Position the bow in the press and crank press inward to
apply a compression force against the limb tips as shown below.
COMPRESS ONLY FAR ENOuGH TO LOOSEN THE STRING AND CABLES.
OvER COMPRESSING COuLD BREAk THE LIMBS AND CAuSE PERSONAL
INjuRY.
ANY DAMAGES INCuRRED FROM OvER-COMPRESSING WILL NOT BE
COvERED uNDER WARRANTY.
X Technology continued on next page
COMPRESSION-TYPE BOW PRESS
one cam bow
hybrid cam bow
cable confiGurations
two cam bow