PSE Archery Bow 2014 - Manual (Page 15)

Compound Bow
USER’S GUIDE
PAGE
15
If you are replacing a PSE Flex slide rod or changing
to a different color follow these instructions.
FIgURE 1:
Unsnap the two strings from the cable slide- noting
the orientation of the two different clips (shorter clip
closest to the riser)
FIgURE 2:
Slide the cable slide off the Flex slide
FIgURE 3:
Using a T9 torx wrench remove the two screws.
Replace with the new Flex slide rod and tighten
the screws.
Re-assembly is the reverse of the
instructions above.
installinG limb bands and cable Guard damper
pse asymmetric idler
Wide edge
Limb Bands on
Split Limb (one per limb)
PSE single cam bows are equipped with a special
asymmetric idler wheel, which is assembled on the
top limb. It is essential that the idler be
oriented properly.
The wide edge of the idler always goes to the
cable guard side of the bow.
The illustration shows the proper orientation of
the idler for a right-handed bow when viewed while
holding the bow as it is shot.
cable guard Damper
check out our line of briGht colored rubber
chanGinG the flex slide rod