Progressive Turf Equipment TD 65-2 Serial Up to 1265-21375 - Manual (Page 37)

34
TROUBLE SHOOTING:
PROBLEM CAUSE REMEDY
Belt slippage Lack of tension
oily drive conditions Increase tension
Clean up drive
Rapid belt wear Belt slippage
belt not in proper
groove Increase tension
Place in proper groove
Belt squeal Belt slippage Increase tension
Over-heated bearings Belt slippage
excessive drive tension Increase Tension
Tension drive properly
Wing deck, corner
support bent Insufficient
spring tension Increase Tension by
adjusting eye bolt
Wing locks hard
to disengage Cylinder not pulling
wing up all the way Adjust clevis on end of
cylinder
Mower deck will
not lower
Vibration on turning.
Input shaft does not
collapse easily on
turning.
Premature spindle
bearing failure.
Orifice in line throttle
valve plugged
Draw bar length
incorrect
Lack of grease at
intermediate location of
drive shaft
Lack of lubrication or
grease is contaminated Remove line throttle
valve, Remove
obstruction from orifice
and reassemble
Adjust drawbar length
To specification
Remove driveshaft and
pull apart. Grease
splines. Grease every 8
hours.
See grease information
and ensure grease being
used is compatible.
Grease per instructions