Cutting height adjustment – Progressive Turf Equipment TD 65-2 Serial Up to 1265-21375 User Manual

Page 27

Text mode
Original mode

CUTTING HEIGHT ADJUSTMENT

§ Mower cutting height adjustment is made by removing lynch pin from the top

of each castor stem (square or round) and corner support and moving the
spacers either above or below support tube as required for your selected
cutting height.

NOTE: Cutting height starts at 1”, with no spacers under the bushing.

Adjust the height using 3/8” and 1” spacers.

§ Be sure all adjustments are set the same.

Spacers (3/8” & 1”)

Bushing

This manual is related to the following products:

TD 65 Serial Up to 1265-21375 TD 65-2 Serial 1365-21376 and Above TD 65 Serial 1365-21376 and Above TD 92 TDR-12 1412037 and Above TDR-12 1312030 - 1312036 SDR-65 10365047 to 13365072 SDR-90 10365047 to 13365072 SDR-65 14365073 and Above SDR-90 14365073 and Above SDR 90 SDR65 TDR-12 Up to 1212029