Progressive Turf Equipment TD 65-2 Serial Up to 1265-21375 - Manual (Page 24)

21
LEVELLING THE MOWER & PTO
For proper mower operation and maximum PTO life, the mower hitch and PTO
driveline must be setup correctly.
a) When the mower is connected to the tractor, the mower hitch frame “A”,
should be as close to level with the ground as possible.
b) The connecting hitch “B” can be removed and turned over to give more
height adjustments. Set in the best position for the mower frame to be as
level as possible.
c) To ensure proper life of the PTO shaft, the driveline from the mower gear
box “D” to the PTO shaft “E” on the tractor should be in a straight line.
CONNECTING THE PTO SHAFT
a) Ensure that the tractor engine is shut off and the parking brake is locked.
b) Holding the PTO against the end of the tractor PTO shaft, rotate the tractor
PTO by hand until the shaft slides on slightly.
c) Slide the locking collar on the PTO backwards, Push the PTO onto the
tractor PTO stub.
d) Release the locking ring and pull the PTO shaft backwards until the
locking mechanism snaps into place.
e) Push the shaft forward and backwards to ensure that this is securely locked
in place.
If the PTO shaft comes off during operation, it may cause personal injury and
damage to the PTO shaft and tractor PTO. When checking, make sure the locking
collar is locked, and that the shaft is not just jammed against the end of the tractor
PTO shaft.