Progressive Turf Equipment Pro-Flex 120 14272040 And Above - Manual (Page 47)

Pro-Flex 120 Series Operator’s Manual
43
SUPPORTING MACHINE FOR SERVICE
(2) Points are available to lift the mower off of the ground for servicing
the transport tires / wheels / bearings at the base of the axle as shown
in the accompanying illustration. Use a bottle or service jack to raise
the wheel from the ground and place a wooden block or other suitable
support under the rectangular tube.
Do not support the machine on cinder blocks, hollow tiles or
other members that may fail under continuous load.
Never perform service on a machine that is supported solely by a
jack. Always ensure proper blocking is placed to support load
during service.
Transport tires must be changed with the wings in the raised
position. Ensure the machine is on a flat, level surface and the
wing locks are fully engaged before attempting to lift the
machine.
TRANSPORT TIRES
Inspect tires daily for wear or damage. Check tire pressures weekly
with an accurate pressure gauge. Do not inflate tires beyond 35 psi.
Mounting and dismounting tires from rims can be dangerous and
should be performed by trained personnel using correct tools,
equipment and procedures.
LONG-TERM STORAGE
If the mower is not to be used for an extended period of time (4
months or longer) it is recommended that the following maintenance
steps are followed:
1) Thoroughly wash mower, removing all grass clipping residue
from deck undersides & mower framework.
2) Add grease to all grease points.
3) Check gearbox oil for proper level.
4) Relieve tension on all V-belts by removing belt from tensioner
pulley.
5) Inspect all drive belts & pulleys.
6) Inspect all blade spindle bearings for excessive play.
7) Inspect all blades for serviceable condition.
When returning the mower to service after long-term storage:
1) Check tightness of all blade fasteners.
2) Add grease to all grease points.
3) Re-install all V-belts on tensioner pulleys.
4) Ensure all pivot points move freely.
5) Change gearbox oil.