Proel PC260 - Manual (Page 15)

15
Recall a Preset
To recall a preset, press the front panel RCL button . The display shows the
RECALL PRESET menu and the current preset in the list of those available
in the internal memory . Using the DATA knob scroll the preset list and select
the preset to be recalled . Valid presets will display the preset name, empty
presets will not display any name . Select a valid preset and push the DATA
knob to confirm .
The display will prompt, “Push DATA to confirm, ESC to abort” . Press the DATA
knob to confirm and load the new preset .
IMPORTANT: Make sure that the new preset is appropriate for
your system, and that the connections to your system are correct
for the current configuration. Failure to do so could cause
unexpected results or damage to the system or its components.
To exit the Recall process without loading a new preset, press the ESC button,
SETUP or any active buttons in the processing menu . ESC button will return
the display to run-time mode . Setup or any active processing menu buttons
will display the corresponding edit screen .
Save a Preset
Edited presets can be saved in one of the User Preset memory locations .
To save a preset, press the SAVE button . The display will show the SAVE
PRESET menu . If the previosly loaded preset was a user preset the cursor
starts from the same user preset . If the previously loaded preset was a
factory preset the cursor starts from the first user preset . Use the DATA knob
to select the user destination . Locations that already have presets saved in
them will display a preset name . Empty locations will display “default” in the
name field . You may select an empty location, or a location of a preset that
will be over-written and push the DATA knob to confirm .
The display will prompt, “Push DATA to confirm, ESC to abort” . Press the DATA
knob to confirm and save the new preset .
Now you have to enter a name: Rotate the DATA knob to select the letter or
symbol, then push the DATA knob to skip to the next character in the name
field . The PC260 provides the complete ANSI character set, in this order:
!"#$%&'()*+,-./0123456789:;<=>?@
ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_`
abcdefghijklmnopqrstuvwxyz{|}~
When the preset is named, press SAVE again .
To exit the Save process without saving a new preset, press the ESC button, SETUP or any active buttons on processing menu . ESC
button will return the display to run-time mode . Setup or any active processing menu buttons willdisplay the corresponding edit screen .
Delete a Preset
Also if doesn't happen very often, sometimes could be necessary to erase a preset, particularly when using the PRESET LOCK mode
or the SPL manager and you need to cancel previously stored preset that rae not used anymore .
To erase a preset you have to recall the "Default" preset (no. 1) and save it in the user location you want to erase: