Datacard Group RL90 - Manual (Page 69)

Laminator error recovery
RP90 Plus E and RL90 User Guide 63
6 Inspect the cartridge:
— If the material on the cartridge is in one piece:
— Turn the cartridge take-up knob counter-clockwise until all
damaged material is wound neatly on the take-up spool.
— If the material is split
or broken:
— Trim the ends of the broken portions evenly.
— Align the end of the
supply material with the
take-up spool and apply
tape to secure.
— Turn the material onto
the take-up spool until
the mended portion is
wound two or three
turns.
7 Replace the loaded laminator
cartridge in the printer until it
clicks into position.
8 Close the printer door.
9 Initialize the patch or topcoat
material by pressing the
laminator’s RESET/K and then
the ENTER key.