Posiflex JIVA KS-7212X - Manual (Page 14)

Part 14
To utilize Alarm Clock Wake Up function, the user should enter the BIOS
setup by pressing “Del” key at system boot up, choose in “Power Management
Setup” and make the “Resume by Alarm” for Alarm Clock Wake Up. Save the
configuration and exit the BIOS setup program.
The Preset Power On Control will then be ready. For LAN wakeup, the item
“PCI Express PM Function” must be enabled in “Power Management Setup”
and an operating caller system connected through LAN to the system is
required. It also requires a qualified networking technician to check the LAN
chip ID of the system for the caller system to wake up.
When the terminal is turned off after a successful boot up with external power
continuously supplied, the preset automatic power on functions will keep
monitoring for the preset conditions and turn on the system when the preset
conditions are met. Please note that if the terminal is improperly turned off
before a complete boot up procedure, the above preset power on control
functions will be disabled until next turning off after a complete boot up.
BRIGHTNESS CONTROL
At left side of the main unit below the
power switch, there are brightness adjust
push button switches and two USB
connectors. Each single press on the +
or – button changes the LCD panel
display brightness by a small amount.
When you press and hold the button the
change will keep on until release or
extreme condition matched.
USB PORTS
There are in total 6 USB ports for external connection: 2 at left side below
power switch and LCD brightness adjust buttons; 4 in I/O area. All of them
comply with USB 2.0 standard.
CUSTOMER DISPLAY
Please follow the instructions on the manual that comes along with the
customer display when it is installed.