Posiflex JIVA KS-7212X - Manual (Page 11)

Part 11
CONNECTING CASH DRAWER (OPTION)
The RJ11 connector in I/O area of the terminal can be used for controlling
most of the common cash drawers available on the market. However, it is most
recommended to use Posiflex CR-2200 or CR-2210 or CR-3100 or CR-4000
or CR-4100 or CR-6300 for best compliance to operate the opening
mechanism and to monitor the drawer open status.
This cable of Cash Drawer has a 6-pole plug at one end and an 8-pole plug at
the other. The 8-pole plug should be inserted into the connector of the cash
drawer which marked “Signal”. The 6-pole plug should be inserted in the
connector marked “CR” which can found in the main connection area in the
system.
The user may also purchase the optional 2-in-1 cash drawer control cable to
control 2 cash drawers in 1 port. It has a 6-pole plug at one end and two 8-pole
plugs at the other. The 6-pole plug should be inserted in the connector marked
“CR” found in the I/O area in the system. Each 8-pole plug should be inserted
into the connector marked “signal cable from POS Printer” at the rear of one of
the cash drawers.
CONNECTING CABLES
To have the re-assembled main unit with stand assembly
ready for operation, please connect all required cables to
the appropriate connectors. Please make sure that each
connector is connected to the correct port with the correct
orientation. Damages due to incorrect connection or
orientation are not covered by product warranty!
Some connectors like the COM3/4 or LAN or CR connector have to be gently
inserted until a click is heard. It is recommended that connectors such as the
COM1/2 and VGA connector be screwed into place once seated.
Adjust the slack of each cable. Use the cable tie arrowed in the right picture to
hold all the cables together. Re-adjust the tilt angle of the screen for best
viewing.
Connect the cables to appropriate external devices through the cable exit at the
bottom of stand assembly. Please make sure that each connector has to be
connected to the right device in the right way.
CAUTION: On doing any insertion or extraction of any connector, please
always hold the connector head itself instead of pulling on the