Posiflex DT-308 - Manual (Page 9)

Part 9
the tab in
guiding hole
and gently
press the key
top down till a
click sound is
heard
as
indicated in the
pictures below.
Failure to do so could result in permanent damage not covered in product
warranty.
Key Identification
The keystroke type programmable keypad is provided with an easy and
durable method for reminding the user of content programmed in each
programmable key. First preprint (or write) in each cell of the attached colored
legend sheet the “name” for each key. Stick each cell to the corresponding key
top and then put on the transparent key cap from the accessories. In this way,
the labeling will be protected and resistant to scratch or rubbing. The
numerical keypad part of the keystroke type keyboard is preprinted with laser
printed keys without the transparent key cap.
If re-labeling of programmable key is required, please use the attached key clip
to hook up the transparent key cap and change the label then re-cap.
For the flat type programmable keyboard, please print (or write) in each cell of
the attached grid legend sheet the “name” for each key and then place in the
whole sheet under the transparent film over the keyboard.
CASH DRAWER CONNECTION
The RJ11 connector in connection area of the DT system can be used for
controlling most of the common cash drawers available on the market.
However, it is most recommended that the Posiflex CR-xxx0 (the fourth digit
of the model number being “0” in each cash drawer series) be used for best
compliance.
The DT system will directly control the cash drawer using the cash drawer port
(CR) both to operate the opening mechanism and to monitor the drawer open
status. The 6-pole plug should be inserted in the connector marked “CR” found
in the main connection area in the system.
Single key top
Latching tab
Double key top Tab in the guide hole