Posiflex DT-308 - Manual (Page 7)

Part 7
INSTALLING PD-201 (OPTION)
Please first have an authorized technician to open the
jumper setting service window on the bottom and set
a DC + 5V support to the COM2/3/4 port that the
PD-201 is to be connected to according to Posiflex
technical information.
Please then open the cable cover and push at the 2
latches toward the system front as marked in the
right picture to remove the UPS battery cover to
show the UPS battery cavity as in the right picture
below.
Take the removed UPS battery cover as the below
picture and push at the 2 latches down to remove
the customer display cover installed on it and
result as the leftmost picture further below.
Now take the PD-201 and first pass its interface
cable to go through the square opening in the UPS
battery cover and insert the 2 lugs at front bottom
of PD-201 as arrowed in the middle picture above
into the correspondent positions arrowed in the
leftmost picture above then press down the 2
latches on rear bottom of PD-201 down till they
firmly click in the UPS battery cover as in the
rightmost picture above. Please double check if the
PD-201 is well inserted.
Before installing the PD-201 + UPS battery cover
assembly into the DT system top cover, please
check the bottom side of the PD-201 + UPS battery
cover assembly to route the interface cable in
between the guide posts on the UPS battery cover as
indicate in the left picture.
Please raise the UPS battery in the UPS battery cavity for a
while if it is installed for passing the PD-201 interface cable
through the passage in the UPS battery cavity together with
the UPS battery cable to enter the connection area as marked
UPS Battery Cover
PD Cover Taken Off
PD-201