Posiflex HT-4612X - Manual (Page 10)

Page 10
below:
1.
Hardware power switch
2.
Software OFF command
3.
Automatic power ON control
4.
Emergency power OFF
Hardware Power Switch
This button is located at bottom front corner of right
side as in right picture and can be used to turn the
system on and off alternatively. When this option is
installed, this hardware switch can also be programmed
to be an ON only switch through software command so that when this switch
is accidentally pressed during system turned on, the system just remains on and
unaffected.
Software Off Command
The system may also be shut down under software control. Please just follow
the arrangement by your system integrator for this capability.
Automatic Power On Control
The system may also turn on according to some preset conditions such as
Modem Ring Up and Alarm Clock Wake Up or LAN Wake Up. To utilize
Modem Ring Up or Alarm Clock Wake Up function, please enter the CMOS
setup by pressing “Del” key at system boot up, choose for “PM Wake Up
Events” in “Power Management Setup” and make the “Ring Power up
Control” enabled for Modem Ring Up or select the “Power Up by Alarm” for
Alarm Clock Wake Up. Save the configuration and exit the CMOS setup
program. The Preset Power on Control will then be ready after a normal power
off. For LAN wakeup, an operating caller system connected through LAN to
the system is required. It also requires a qualified networking technician to
check the LAN chip ID of the HT-4600(E/X)/PB-4600(E) system for the caller
system to wake it up.
When the HT-4600(E/X)/PB-4600(E) system is turned off after a successful
boot up, the preset automatic power on functions will keep monitoring for the
preset conditions and turn on the system when the preset conditions are met.
Please note that if the HT-4612(E /X)/PB-4600(E) system is improperly turned
off before a complete boot up procedure, the above preset power on control
functions will be disabled until next turning off after a complete boot up.