OpenEye G4 GraniteRack - Manual (Page 19)

31822AE 19
NETWORK CONFIGURATION
There are multiple network ports on your G4 GraniteRack. The most important connections are the two
network ports on the motherboard. Connect these as a bonded pair to the paired VLAN 1 portion of the
24-port switch.
Configure Team Networking
To configure these ports to operate as a bonded pair, follow these instructions.
1. In the Initial Configuration Tasks window, click Configure Networking.
2. Right-click 1
st
Local Area Connection Intel® 82579LM.
3. Click Properties.
4. Click Configure.
5. Click the Teaming tab.
6. Select Team This Adapter with Other Adapters, and then click New Team.
7. Type a Team Name. This name should be descriptive of the purpose or location of the storage unit,
such as “Warehouse,” or “West Campus.”
8. Click Next.
9. Select both 82574L Gigabit Network Connection, and 82579L Gigabit Network Connection.
10. Click Next.
11. Click Finish.
12. Click OK, and then click OK again to complete this configuration.
Set Team IP Properties
Consult your system administrator before configuring these settings.
1. In the Initial Configuration Tasks window, click Team, and then click Properties.
2. Double-click Internet Protocol Version 4.
3. Select Use the Following IP Address.
4. Type the appropriate IP Address, Subnet Mask, and Default Gateway.
5. Type the appropriate DNS Server, and an Alternate DNS Server, if applicable.
6. Close the window.
You can also make the following adjustments as needed:
•
Add computer Name and Domain
•
Enable Automatic Updating and Feedback
•
Download and Install Updates
Note Enabling Automatic Updating and Feedback could cause the G4 GraniteRack to restart
unexpectedly and lose data. OpenEye does not recommend enabling Automatic Updating and
Feedback.