OpenEye Gen6 N-Series - Manual (Page 64)

32521AD 65
Status Check / Email
Use the Status Check/Email tab in Storage Management to configure settings for status checks and
email recipients when status checks require attention. This function can keep you apprised of events
detected by your system without requiring you to check check the recorder each day.
1. On the Display screen, click Setup .
2. Click Storage Management .
3. Click the Status Check/Email tab.
4. Click the General tab.
5. Select Enable Email Alarm .
6. Enter a From Name and email Address .
Note This name and address will appear in the From line of
email alert messages.
7. Enter the SMTP information for the email account that will
be used to send emails from the recorder. Contact your
administrator for this information if necessary.
8. If using a secondary email account select Use Secondary
SMTP and complete the SMTP information.
9. Click Test to send a test message to either address.
10. Click Apply to save your settings.
1. On the Display screen, click Setup .
2. Click Storage Management .
3. Click the Status Check/Email tab.
4. Click the Users tab.
5. Select the type of Event to send email on.
6. Enter the User and E-mail Address of a desired recipient.
7. Click Add .
8. Repeat for additional recipients and types of events.
Note A separate email notification for each type of event
must be set up for a single recipient to receive
notifications for each type of event.
9. Click Apply to save your settings.