OpenEye Gen6 N-Series - Manual (Page 53)

54
This interface is used to link Hard Contact Sensor Inputs from supported Network Devices to the
recorder software.
1. Click Setup .
2. Select a camera from the Network Device List .
3. In the Sensor Relay list, double-click DVR Sensor No and then select a sensor to assign to this
camera.
4. Double-click DVR Relay No , and then select a relay to assign to this camera.
5. Click Apply .
6. Click Apply again to save your settings.
Relays
1. Double-click Relay Name for each relay to
assign a name.
2. Click Apply to save your settings.