Omnia Audio Omnia.ONE User Manual
Page 72
53
[Abs Thresh] (Absolute Threshold)
Sets a failover threshold based on the absolute level of the primary input.
[Rel Thresh] (Relative Threshold)
Sets a failover threshold relative to the secondary input level.
[Fover Src] (Failover Source)
Failover Source selects which audio input: Analog, AES/EBU (digital) or Livewire will
serve as the secondary audio input. Note that the audio input that is selected under Input
Source (above) will always be the Primary audio input. A source selected under Failover
Source will always be the secondary source.
<-Exit
Click on this option to return to the Discrete I/O submenu.
Anlg Level
Adjusts the master analog input level of both channels over a range of +/- 12.0dB in 0.5dB steps.
Right Trim
Adjusts the level of the right channel input only over a range of +/- 3.0dB in 0.1dB steps.
AES Level
Adjusts the master AES/EBU digital input level of both channels over a range of +/- 12.0dB in
0.5dB steps.
Right Trim
Adjusts the level of the right channel input only over a range of +/- 3.0dB in 0.1dB steps.
LW Level
Adjusts the master Livewire input level of both channels over a range of +/- 12.0dB in 0.5dB
steps.
Right Trim
Adjusts the level of the right channel input only over a range of +/- 3.0dB in 0.1dB steps.
Invert
Inverts the phase of one channel (L inverts only the left channel) (R inverts only the right channel)
or BOTH channels. None (the default) passes through both channels normally.
Mono Mode
Allows input signal routing to be reconfigured as follows:
[STEREO] - Factory default. Left and Right input channels are routed to the left and right inputs
to the DSP processing chain.
[Mono L] - Configures the DSP processing chain to have both the Left and Right internal channels
fed only from the Left Channel of the input source selected. Note that this selection is active in all
sources selected as Primary and Secondary (Failover) audio sources.
[Mono R] - Configures the DSP processing chain to have both the Left and Right internal channels
fed only from the Right Channel of the input source selected. Note that this selection is active in
all sources selected as Primary and Secondary (Failover) audio sources.