Dynex DX-PDP42-09 - Manual (Page 23)

Specifications 23
Audio problems
PC mode problems
Specifications
Legal notices
FCC Part 15
This device complies with Part 15 of the FCC Rules. Operation of this product is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply within the limits for a class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced technician for help.
Problem Solution
Picture okay, but
no sound • Press the volume control to increase the
volume.
• Press MUTE to make sure that your TV is not
muted.
• Try another channel. The problem may be with
the broadcast.
• Make sure that the audio cables are installed
correctly.
No output from
one of the
speakers • Adjust the balance in the AUDIO menu.
Unusual sound
from inside the
TV • A change in ambient humidity or temperature
may result in an unusual noise when the
product is turned on or off. This does not
indicate a fault with the product.
Problem Solution
The signal is out
of range • Adjust the resolution, horizontal frequency, or
vertical frequency.
• Check the input source.
Vertical bar or
stripe on the
background,
horizontal noise,
or incorrect
position • Adjust the clock, phase, or horizontal/vertical
position, or try Auto to configure these options.
The screen color
is unstable or a
single color • Check the signal cable to make sure that it is
connected correctly.
• Reinstall your PC’s video card.
Plasma panel Panel size 42-inch plasma
Aspect ratio 16:9
Brightness 1500 cd/m2
Contrast ratio 10,000:1
Max. resolution 1024 × 768
Maximum colors 16.7 million
Input
connector Video/Audio (L/R) in 2
S-Video/Audio (L/R) in 1
YPbPr/Audio (L/R) 2
VGA/Audio (L/R) 1
HDMI/Audio (L/R) 2
Audio out (L/R) 1
Optical 1
Headphone 1
Power source 100-240V AC, 50/60 Hz
Power
consumption 310 W
Standby <1 W
Dimensions 41.26 Ч 28.5 Ч 10.7 inches
(1048 Ч 724.4 Ч 272 mm)
Weight 51.81 lbs. (23.5 kg)