MovinCool Classic Plus 14 - Manual (Page 24)

24
OPERATION (cont.)
Operating Modes
The Classic Plus 14 and Classic Plus 26 can be operated in two modes, FAN
ONLY and COOL. When in FAN ONLY mode, the unit circulates the surrounding
air. When in COOL mode, the compressor is operated and cool air is circulated.
1. COOL Mode
Once the compressor has been disengaged for more than 120 sec, the unit
operates in FAN ONLY mode for approximately 5 sec before the compressor
re-engages. (Time delay setting is around 120 sec.)
2. Temperature Control
The room temperature thermistor monitors the inlet temperature versus set
point temperature and switches the unit automatically between COOL and
FAN ONLY modes.
3. Fan Mode Control DIP Switch
The fan mode control DIP switch determines whether the fan continues to
operate or stop when the compressor cycles off. (Set point temperature equals
inlet air or room temperature.) The unit has been preset at the factory for
continuous fan operation.
Note: If you want to change the fan mode operation (from OPERATE to
STOP), contact your MovinCool reseller.
4. Temperature Scale Display DIP Switch
The temperature scale display DIP switch changes the temperature(s) that are
displayed to either °C or °F. The unit has been preset from the factory to
display the temperature(s) in °F.
Note: If you want to change the temperature scale display (from °F to °C),
contact your MovinCool reseller.