MovinCool Classic Plus 14 - Manual (Page 11)

11
INSTALLATION (cont.)
Plugging in the Unit
1. Check the prongs and surface of the power cord plug for dust/dirt. If dust and/
or dirt are present, wipe off with a clean, dry cloth.
2. Check the power cord, plug and prongs for damage or excess play. If any
damage or excess play is found, contact your MovinCool reseller or a qualified
technician for repair.
WARNING:
1. If the power cord or plug is damaged, repair should only be
performed by qualified electrical personnel.
2. Do not connect/disconnect the power cord or attempt to operate
buttons with wet hands. This could result in electrical shock.
CAUTION:
1. Classic Plus 14 ONLY: The AC outlet (115 VAC Single Phase, 60 Hz)
needs to be rated at 15 A or higher. Do not share the outlet with any
other instrument or equipment.
2. Classic Plus 26 ONLY: The AC outlet (208/230 VAC Single Phase,
60 Hz) needs to be rated at 20 A or higher. Do not share the outlet
with any other instrument or equipment.
Note:
1. Make sure the AC outlet is free of dirt, dust, oil, water, or any other foreign
matter.
2. The Classic Plus 14 is equipped with a UL approved LCDI cord and an
approved NEMA plug configuration (5-15). The appropriate outlet must be
used for this plug type.
3. The Classic Plus 26 is equipped with a UL approved LCDI cord and an
approved NEMA plug configuration (6-20). The appropriate outlet must be
used for this plug type.