Montigo RX88 - Manual (Page 14)

1
Flame Height Control
Proflame gT: with the system on, and the flame present in the appliance, pressing the Down
Arrow Key (Fig. 1) will turn OFF the flame while the remote system is still on. If the Up Urrow Key
is pressed while in the above described state the flame will come on. ( Fig. 9A & 9D)
Proflame gTM & gTMF: has six (6) flame levels. With the system on, and the flame level at the
maximum in the appliance, pressing the Down Arrow Key (Fig. 1) once will reduce the flame
height by one step until the flame is turned OFF.
The Up Arrow Key will increase the flame height each time it is pressed. If the Up Arrow Key is
pressed while the system is on but the flame is off, the flame will come on in the high position.
( Fig. 9A & 9B & 9C& 9D ) A single “beep” will confirm reception of the command.
Fig. 8: Fig. 9A: Flame Off Fig. 9B: Flame Level 1
Fig. 9: Fig. 9C: Flame level 5 Fig. 9D: Flame Level Maximum
Fig. 9: Fig. 9E Fig. 9F
Split flow function ( gTMS & gTMFS only )
The secondary burner is controlled by the split Flow. To activate this function use the Mode Key
(Fig. 1) to index to the SPLIT FLOW icon (Fig. 9E & 9F). Pressing the Up Arrow Key will activate
the secondary burner. Pressing the Down Arrow Key will turn the secondary burner OFF. A single
“beep” will confirm the reception of the command.
0_I00_gtmf_cat_only 0-1 1 1/0/00 1.1.