Temp, Manual function, Thermostat function – Montigo 1001 TH-A User Manual
Page 2
Rev. 8/22/05 Page 2 of 9
SETTING
0
F /
0
C SCALE
The factory setting for temperature is
0
F. To change this setting to
0
C,
first
•
Press the ON key and the OFF key on the transmitter at the same
time this will change from
0
F to
0
C. Follow this same procedure to
change from
0
C back to
0
F.
MANUAL FUNCTION
To operate the system in the manual “MODE” does the following.
ON OPERATION
Press the ON key the appliance flame will come on. During this time the
LCD screen will show ON, after 3 seconds the LCD screen will default
to display room temperature and the word TEMP will show. (Flame icon
will appear on LCD screen in on mode)
OFF OPERATION
Press the OFF key the appliance flame will shut off. During this time the
LCD screen will show OF, after 3 seconds the LCD screen will default to
display room temperature and the word “TEMP” will also show on the
screen.
THERMOSTAT FUNCTION
SETTING DESIRED ROOM TEMPERATURE
This remote control system can be thermostatically controlled when the
transmitter is in the THERMO mode (The word ROOM must be
displayed on the screen). To set the THERMO MODE and DESIRED
room temperature,
Press the MODE key until the LCD screen shows the word ROOM,
then the remote is in the thermostatic mode.
Press and hold the SET key until the desired set temperature is
reached. (By pressing and holding the set key the LCD screen set
numbers will increase from 45
0
to 99
0
then restart over at 45
0
) Next
release the SET key. The LCD screen will display the set temperature
for 3 seconds and the LCD screen will flash the set temperature for 3
seconds, then the LCD screen will default to display the room
temperature.
TO CHANGE THE SET TEMPERATURE
Press and hold the SET key until the desired set temperature is
reached. (By pressing and holding the set key the LCD screen set
numbers will increase from 45
0
to 99
0
then restart over at 45
0
) Next
release the SET key. The LCD screen will display the set temperature
for 3 seconds, then will flash the set temperature for 3 seconds, then the
LCD screen will default to display the room temperature.
TEMP
TEMP
SET
THERMO SET
SCREEN WHILE
DEPRESSING OFF
KEY
TEMP
SCREEN AFTER 3
SECOND DEFAULT
ROOM
TEMP
THERMO MODE
TEMP
SCREEN AFTER 3
SECOND DEFAULT
ROOM
TEMP
THERMO ON
ROOM
TEMP
THERMO OFF
SCREEN WHILE
DEPRESSING ON
KEY